An experimental system for release simulation of internal stores in a supersonic wind tunnel

Aerodynamic parameters obtained from separation experiments of internal stores in a wind tunnel are significant in aircraft designs. Accurate wind tunnel tests can help to improve the release stability of the stores and in-flight safety of the aircrafts in supersonic environments.A simulative system for free drop experiments of internal stores based on a practical project is provided in this paper. The system contains a store release mechanism, a control system and an attitude measurement system. The release mechanism adopts a six-bar linkage driven by a cylinder, which ensures the release stability. The structure and initial aerodynamic parameters of the stores are also designed and adjusted. A high speed vision measurement system for high speed rolling targets is utilized to measure the pose parameters of the internal store models and an optimizing method for the coordinates of markers is presented based on a priori model. The experimental results show excellent repeatability of the system, and indicate that the position measurement precision is less than0.13 mm, and the attitude measurement precision for pitch and yaw angles is less than 0.126°, satisfying the requirements of practical wind tunnel tests. A separation experiment for the internal stores is also conducted in the FL-3 wind tunnel of China Aerodynamics Research Institute.     

高性能混凝土的外加剂优化研究(英文)

运用不同减水剂和早强剂配制高性能混凝土(High performance concrete,HPC),测定其工作性、标准养护强度和蒸汽养护强度,研究了HPC的外加剂选用原则。结果表明,掺加聚缩酸系高效减水剂有利于HPC获得高工作性和高强度。硫酸钠早强剂将导致工作性不好,强度降低。对于蒸汽养护的HPC制品,应该优先采用硫酸钠含量低的萘系高效减水剂。因此,HPC外加剂的选择应该考虑养护条件的差异。     

基于响应面近似技术的平流层飞艇协同设计优化

针对平流层飞艇多学科设计优化问题,引入协同优化算法,分析基于响应面近似模型的协同优化方法CO/RSA的执行步骤和特点,并介绍响应面近似模型的构建方法;建立平流层飞艇各学科模型,并对学科间耦合关系进行分析;运用建立的气动/推进、结构、能源三个耦合子系统的学科分析模型和系统优化模型,以平流层飞艇总质量最小为优化目标,综合考虑浮重、推阻和能源平衡,采用CO/RSA方法对平流层飞艇进行设计优化.结果表明:所建立的平流层飞艇的MDO模型是合理的,CO/RSA算法应用于飞艇总体设计优化是有效的,研究结果可为平流层飞艇方案论证和方案设计提供参考.     

Effect of sodium tartrate concentrations on morphology and characteristics of anodic oxide film on titanium alloy Ti–10V–2Fe–3Al

The effect of sodium tartrate concentrations on morphology and characteristics of ano-dic oxide film on titanium alloy was investigated. The alloy substrates were anodized in different concentration solutions of sodium tartrate with the addition of PTFE emulsion and their morphol-ogy and characteristics were analyzed. The anodic oxide film presented a uniform petaloid drums and micro-cracks morphology. Additionally, micro-cracks dramatically swelled with the increase of the tartrate concentrations. The thickness of the anodic oxide film increased with the concentra-tions until the concentration reached 15 g/L. The results of Raman analysis illustrate that all sam-ples have similarity in the crystal structure, consisting of mainly amorphous TiO2, some anatase TiO2 and a small amount of rutile TiO2. And the ratios of anatase TiO2 and rutile TiO2 increase with the concentrations until it reaches 15 g/L. Furthermore, the intensity of the peaks increases with enhanced concentrations until the concentration reaches 15 g/L. The corrosion resistance of the anodic oxide film is increased by the sodium tartrate with higher concentrations before 15 g/L. The coefficient of friction of the anodic oxide film reduces with the concentrations until the concentration reaches 15 g/L, then the coefficient of friction of the anodic oxide film increases with the concentrations.     

航空锂电池适航审定规章解读及符合性方法研究

锂离子电池作为动力电池有着优异的性能,在民航行业上有广阔的应用前景。但行业对其技术特征 和安全风险的认识还不充分,现行的规章条款缺乏足够的安全要求,国外局方针对锂离子电池颁发了专用条 件,但回顾相关事故可以发现,锂离子电池的验证和审查环节还不完善,相关条款更新修正的步伐也同锂电池 的发展现状和技术水平不相适应。以航空锂电池事故为例,分析航空锂离子电池作为动力电池的安全性风险, 从对现有规章条款和专用条件的解读出发,借鉴不同行业近年来积累的锂电池验证和使用经验,针对航空动力 锂电池的适航符合性方法提出一些改进方案,可作为现有锂电池适航符合性方法的有益补充,为自主建立健全 适航验证规范体系做出探索。     

配对进近模式分析及研究进展

配对进近模式是在近距平行跑道上运行的,旨在提高仪表气象条件下的进场效率的一种高效进近模 式,该模式的完整流程在国内鲜有阐述。本文重点分析配对进近程序在近距平行跑道上运行时各阶段的流程, 以及配对进近程序的实施对机型、设备以及人员的具体要求;结合目前国内近距平行跑道的运行情况,国际上 对配对进近模式的研究和应用现状,指出我国引进配对进近模式的迫切性以及该模式今后的研究和发展趋势。     

基于HTN的卫星应用任为分解方法

文章在深入分析卫星应用任务复杂性的基础上,研究了层次任务网络(HTN)方法对复杂卫星应用任务分解问题的适用性,并给出了相应的问题求解框架;深入研究了卫星应用任务需求要素预处理工作的主要内容和步骤,并在此基础上构建了卫星应用任务的域模型;最后给出了复杂任务及其分解方法的定义,采用基于HTN的方法对复杂卫星应用任务分解问题进行求解,同时给出了基于HTN的状态空间前向搜索算法.     

×××机翼主梁的寿命分布研究

本文通过运用Ｗ∧２统计量的检验方法对ＸＸＸ飞机八个失效的机翼主梁寿命分布进行了检验，得出该主梁寿命分布为威布尔分布。     

分布式航天器相对位置测量平台设计

分布式航天器间相对位置的实时高精度测量是分布式航天器实现空间队形保持的关键技术之一。为了对相对位置测量方法进行研究、分析和论证，建立了分布式航天器相对位置测量地面实验平台。介绍了分布式航天器相对位置测量和解算的基本原理；论述了仿真平台的组成和功能；基于仿真平台对相对位置测量精度进行了仿真试验，试验结果显示该平台具有良好的性能指标；最后介绍了相对位置解算仿真评估软件的设计方法。     

Characterization and Calibration of the CheMin Mineralogical Instrument on Mars Science Laboratory

A principal goal of the Mars Science Laboratory (MSL) rover Curiosity is to identify and characterize past habitable environments on Mars. Determination of the mineralogical and chemical composition of Martian rocks and soils constrains their formation and alteration pathways, providing information on climate and habitability through time. The CheMin X-ray diffraction (XRD) and X-ray fluorescence (XRF) instrument on MSL will return accurate mineralogical identifications and quantitative phase abundances for scooped soil samples and drilled rock powders collected at Gale Crater during Curiosity’s 1-Mars-year nominal mission. The instrument has a Co X-ray source and a cooled charge-coupled device (CCD) detector arranged in transmission geometry with the sample. CheMin’s angular range of 5^° to 50^° 2θ with <0.35^° 2θ resolution is sufficient to identify and quantify virtually all minerals. CheMin’s XRF requirement was descoped for technical and budgetary reasons. However, X-ray energy discrimination is still required to separate Co?Kα from Co?Kβ and Fe?Kα photons. The X-ray energy-dispersive histograms (EDH) returned along with XRD for instrument evaluation should be useful in identifying elements Z>13 that are contained in the sample. The CheMin XRD is equipped with internal chemical and mineralogical standards and 27 reusable sample cells with either Mylar^? or Kapton^? windows to accommodate acidic-to-basic environmental conditions. The CheMin flight model (FM) instrument will be calibrated utilizing analyses of common samples against a demonstration-model (DM) instrument and CheMin-like laboratory instruments. The samples include phyllosilicate and sulfate minerals that are expected at Gale crater on the basis of remote sensing observations.